Timer Unit, control our Perimeter Beam kits, 1 sec to 3 minute activation

Alarm Panel too complicated, too big and obtrusive, concerned about wiring and setup... try one of these it is so easy only 8 connections to make, to check out the very simple wiring click on the above image.

A quick and easy to install timer controller that will accept one or multiple Beams (parallel connection) extremely easy to connect up and can be used outside if installed in an IP rated weatherproof box, no heat is generated so no cooling is required.

An on board control which when turned fully anti-clockwise fires the Siren for 1 second , clockwise varies the setting up to 3 minutes..  

After activation the Timer unit resets and waits for the next trigger, if the Beams are still blocked the unit will reactivate and carry on to fire the Siren.

An on board relay with Normally Open or Normally Closed contacts will allow external relays to be incorporated that will let you control Lighting, 12 Volt Sirens and even the mighty Klaxon Masterblaster etc. etc. 

This unit is bulletproof reliability, all Analogue non-digital electronics.

To Power this unit all you need extra is:

1 x Power Supply 12V our Stock Code: PSU1 and a connector stock code: 2.1S

This is a simple easy to install,  timer adjustable to run from 1 sec to 3 minutes, ideal for use with our Infra red beam kits so when triggered the alarm runs for the preset time then resets. Suitable for internal use only , but could be mounted externally if installed in an IP66 rated box.

The only additional items required is a 12V power supply (PSU/12V/2000) and 1 x 2.1mm power socket (CON2.1S) & if you need cables add 1 x box of CAT5e Cable (CABCAT5e) ,

This unit will drive any siren or buzzer that activates when 12V DC is added, we do have an internal buzzer available approx £8.50 (BUZZ1) and we have small external approx 115 db Sirens with a Red Strobe for  £9.50  (Stock Code: Siren1/Strobe) works perfectly with this unit.

Still cheaper than any alarm panel and so much easier to install, a sample wiring diagram for connecting any of our Beams is shown by clicking on the image at the top and proceed to 2nd image

Timer range:  1 sec to 3 minutes, adjusts with on board small control

Power:12 V DC, 60mA, reverse voltage protection built in.

Output : Relay switched 5A loadable

Dimensions:75mm x 45 x 25mm