CCTV Hum Filter " The Humblocker Solo"

Buy 3 get 1 Free on this product, simply put 3 Humblockers in your basket and when we pick your order we will include a 4th Humblocker Free of Charge.

Cost per item on this offer equates to only £15.00 each

Our free delivery applies to this product.

This is the best product of its type on the market and is the only device which using dual coils switches the type of noise filtering when the I/R comes on, unique  built in filtering eliminates most I/R banding noise and takes over where all the others seem to fail, still not the most expensive but the best on the market.

Again even more Anti-Thunder and Surge protection built in.

This hum filter is of amazing high quality and has 120mm input & output pigtails with BNC Plugs & Sockets fitted for easy plug in installation, filters out noise from varying earth potentials at the same time.,

Hum or Banding up the screen is very common when Poor Quality RG59+2 Cable is used (Shotgun Cable) and is simply caused by low quality Cable, another source of Noise is when Cat5e is used and especially quality of most offered for sale is usually copper over aluminium where ideally it should be solid copper and because of the long distances involved power that is local to the camera has to be used, resulting in power from a different earth potential compared with the earth potential where the DVR is...CAT5e that has aluminium content is a little more prone to noise collection than solid copper.

If you use our BALUN/POE/A these have a "Humblocker Solo" built in so noise is very rare indeed and images become automatically electronically balancd and stable.

Our installer clients report that they have gone through all possible brands of noise elimination, most will cure daytime banding, but fail when the I/R comes on, but when the Humblocker Solo is used it cures where all the others fail, other than this it is a bad cable issue.

This is a Hum blocker for CCTV, filters out noise and banding caused by variations in earth potentials or imbalances, can be caused when cameras are powered from a supply with different earth levels than the DVR's power, the most common occurence is when Cameras are powered from local sockets to the Camera , e.g outbuidings etc. unit can also remove noise picked up from local mains cableing and smooth out ripples in images when IR turns on.

A common man made cause is when CCTV Cables are running parallel with active power cables, the Humblocker can provide inbuilt resistance to this problem and in many cases removes the need to have cables re-routed, being especially effective when in I/R mode as the frequency change makes the intrusion of noise even easier but harder to cure, .. try the Humblocker.

Unit has 240mm pigtails and Male & Female BNC's for the input & output, totally passive simply plug into the DVR 

Anti-Surge & Anti-Thunder built in which adds protection to the DVR ports.

To install simply unplug the Camera Cable from the DVR and connect the Humblocker Solo to the DVR then plug the Camera Cable into the Humblocker   " Job Done"

Please refer to our installation guide for assistance with Video noise

To Follow