8 Channel CCTV Camera Power supply, 12V DC 15 Amps, Fan Cooled,

This unit can be free standing or wall mounted.

versatile 8 Channel 12 Volt Fan Cooled Power Supply, a high 15 Amp rating for CCTV cameras that can operate at a full load and still stay cool,

8 x 2.1mm Power Sockets included Free of Charge, this means you do not have to open the unit to connect up.

This unit will drive any combination of 8 x 12V DC cameras available on the market. To date we have assembled here in Stoke on Trent thousands of  this type of Power Supply unit,

This unit comes with an IEC kettle lead with a UK 13 Amp plug, totally plug n' play , a qualified electrician is not required to install this

8 x Male & Female 2.1mm Power plugs  are supplied to complete the installation to easily connect the Camera Power Cables to this Power Supply, the 2.1mm standard Power plugs are moulded to the Flying Leads, all you need is a small flat screwdriver.

This is a sealed Switched Mode 12V Power Supply recently upgraded to deliver a massive 15 Amps across all 8 outputs, all 8 outputs are shared but variable, e.g. 1 Channel could draw 3 amps say for a Speed Dome and the other 7 can draw any combined current up to the total loading of 15 Amps, makes this more practical than a fixed output per channel Power Supply, also unit is fan cooled with a quiet 80mm fan

If a short circuit occurs this unit will electronically shut down and hold off until the fault is rectified, no trips,  no fuses.

Unit does not have to be opened to connect up, 8 +ve and 8 -ve outputs are on a "Spider Lead"  connections are terminated with 2,1mm plugs, 8 x 2.1mm sockets with screw terminals are supplied in with kit, a white plastic wall mounting kit is included.

A fused 13A plug-top Kettle lead is supplied which simply plugs into the Kettle type socket on the Power Supply , an external Mains On/OFF switch is built into the Rear Panel.

Channels: 8 output ports on "Spider Leads" moulded 2.1mm plugs

Connectors: 8 x 2.1mm Plugs , 8 x 2.1mm Sockets are provided in the kit

Cooling: 80cm virtually quiet fan, 3000 RPM 

Power input: 240Vac 3 pin IEC Socket,  Internal but visible Power On LED

Power Output: 12V DC up to 15 Amps, with electronic Short Circuit protection

Method: Switched Mode

Chassis: Emission free Sealed Steel Housing, 

Cooling: 80mm Cooling Fan..

Cables: Mains Kettle Lead included, with fused Plug top & IEC 3 pin plug

Dimensions: 85mm x 150 x 142mm

Chassis:  Steel with white platic Wall mounting kit.

Warranty: 12 months