30 Metre Infra Red Perimeter Dual Beams, Lowest UK Pricing

Great or the driveway or rear gardens,

Lowest cost in the UK for this product with this specification & free delivery.

Price could change any day, buy now loads in stock today.

Massive range and loads more Power at the same price, and a Breeze to install, simply an amazing piece of kit, be safe buy these now. Receiver has an LCD Display for Signal strength, makes setting up easy.

Low cost most effective perimeter surveillance, how else can 30 Metres of fencing be bought for £29.99 Dual Infra Red Beams which are invisible, can be set up with the transmitter and receiver , as far as 30 Metres apart and can detect intruders before they reach your house or factory, connects to a standard alarm panel, or our low cost timer unit Part Code: TIMER1, check out this item and you will see the wiring diagram.

You can also connect to any of our DVR's to trigger a Camera to record so recording periods could run into years, or trigger an external alarm. so please discuss with your installer how an Auto-Dialler can be added and this will then ring preselected mobiles until it with gets an answer so you will know that someone has crossed the Beams.

Unit can be powered from a standard Panel and can be wired with Alarm Cable or even better CAT5e. Simply connect as you would a PIR In use by The British Transport Police, Military, Airports, Airfields & Airbases, The Prison Service, Factory Units, Houses, Farms and Garden Centres, Stately Homes and Museums. or any restricted area

This a brand new design of Dual Infra Red Beams with a Transmitter and Receiver in the kit, range is 30 Metres outdoor and even greater indoors,

Ideal for perimeter detection of intruders , usually set a waist height allows wild life to walk under the beams, both beams have to be broken to activate the receiver unit.

Minimum installable distance about 3 Metres Can be Pole Mounted, on Walls, Trees even looking up and down slopes up to 20 degrees and be can adjusted 180 degrees horizontally allowing close scanning down a wall, factory wall or across a large flat roof.

Kit includes wall & pole mount fittings

Activation is triggered when both Beams are broken for set period of microseconds therefore birds etc do not activate the alarm.

Unit has a built in eyesight viewers to Assist setup especially over very long distances,

Both units are very low consumption at 12V DC and link to a standard alarm Panel using a choice of Normally Open or Normally closed contacts, an output relay is also included. Sets can be crossed if kept a few Metres apart and detect intruders especially into large gardens , farms etc before they reach the house, think about putting an autodialler onto your panel so it calls you when the beams are crossed, We also have Remote controls with multiple Key Fobs as an optional extra so you can activate just the beams as you enter and leave the property. Wiring back to the panel can be done with alarm wire or CAT5e , Cat5e is better, less volt drop and cheaper), Transmitter requires 12V DC and the Receiver requires 12V DC and one of the twisted pairs in the Cat5e back to the panel to trigger an alarm. All the 12V Power can be fed from your existing panel or for an easy installation our TIMER1 can feed the 12V DC requirement.

Guarding Distance: Up to 30 Metres outside, up to 40M inside.

Installation Options: Wall mount integrated, Pole Mount kit (included)

Contacts: Normally open (NO) or Normally Closed (NC)

Setup: Integrated aiming unit, & Multimeter test points on Receiver

Frequency: Fixed

Response Speed: 50 - 700mS

Alarm output: Relay contact, NO/NC DC30V 0.5A max

Power Consumption: <0.3mA standbay, Alarm: 40mA

No of Beams: 2 Detection Mode: Both beams have to be blocked at the same time

Optical Source: Infrared Digitally Pulsed Beam

Power: DC 12V - 13.8V, 55mA max in alarm status, <0.3mA on standby

Optical Adjustment (H) / (V): 180 deg +/- 90 deg... 20 deg +/- 10 deg

Housing: Anti-Vandal Very strong ABS Resin